Roche ACCU-CHEK Inform II Instrukcja Operatora Pobierz pdf (Strona 121)

Maintenance and Care

121

Cleaning the meter

■ Wipe the surfaces with a soft cloth slightly

dampened (not wet) or you may spray the meter

per the directions mentioned below.

■ Remove the meter from the base unit prior to

cleaning.

■ Do not clean the meter while performing a patient

or control test.

■ Place the meter on a level surface while wiping over

the test strip port area, making sure that no liquid

enters the strip port.

■ Dry the meter thoroughly after cleaning. Visually

verify that no solution is seen anywhere on the

meter at the completion of cleaning. If cleaning

fluid is allowed to collect in any opening, severe

damage can occur to the meter and the base unit.

■ If using commercially available pre-moistened

cleaning cloths, squeeze off excess cleaning

solution or blot on a dry paper towel to remove any

excess cleaning solution before cleaning the

surface of the meter.

■ If spraying the meter, place it on a flat surface or

table. Wear gloves. Be aware that the meter may

become slippery when wet. Do not let the meter

drop! Do not spray while the meter is docked in the

base unit!

Cleaning the barcode scanner

window

The barcode scanner window should be cleaned periodi-

cally. Use a clean, dry cloth to wipe the barcode scanner

window.

NOTICE

Ensure meter/base unit (including connectors) are thor-

oughly dried after cleaning or disinfecting.

WARNING

Do not spray directly into the strip port!

Moisture in the strip port may lead to incorrect blood

glucose results. If you suspect that moisture may have

entered the strip port, perform a glucose control test.

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 159 160

Brak uwag

Roche ACCU-CHEK Inform II Instrukcja Operatora Strona 121